Determine the static safety factor if the spring is subjected to a static load of 175 N.

1.       Three springs are arranged in parallel like the configuration shown in Figure 3-1(b). They have spring rates k1 = 50 N/mm, k2= 150 N/mm, and k= 500 N/mm, respectively. Determine the total spring rate, the force carried by each spring, and the overall deflection if a load of = 600 N is applied.

2.       A spring made from ASTM A228 wire with ends squared and ground, wire diameter = 3 mm, outside diameter D= 27 mm, 14 total coils, and free length Lf = 80 mm has been chosen for an application. Determine the static safety factor if the spring is subjected to a static load of 175 N.

find the cost of your paper

Calculate the maximum achievable bridge out-of-balance voltage for an applied torque T of 103 N m given the following

Four strain gauges, with specification given below, are available to measure the torque on a cylindrical shaft 4 cm in diameter connecting a motor and load. (a) Draw clearly labelled….

Find the gain and phase characteristics of the maintaining amplifier.

A solid-state capacitive humidity sensor has a capacitance given by: C = 1.7 RH + 365pF where RH is the percentage relative humidity. The sensor has an associated parallel resistance….

calculate the mean velocity of the gas at maximum flow rate

A pitot tube is used to measure the mean velocity of high pressure gas in a 0.15 m diameter pipe. At maximum flow rate the mean pitot differential pressure is….