Find the lead, lead angle, worm-gear diameter, and center distance. Will it self-lock? The input speed is 2 200 rpm.

1.       A paper machine processes rolls of paper having a density of 984 kg/m3. The paper roll is 1.50-m outside dia (OD) X 0.22-m inside dia (ID) X 3.23 m long and is on a simply supported, hollow, steel shaft with Sut = 400 MPa. Design a 2.5:1 reduction helical gearset to drive this roll shaft to obtain a minimum dynamic safety factor of 2 for a 10-year life if the shaft OD is 0.22 m and the roll turns at 50 rpm with 1.2 hp absorbed.

2.       A 2-start wormset has = 50 mm, px = 10 mm, mG = 22:1. Find the lead, lead angle, worm-gear diameter, and center distance. Will it self-lock? The input speed is 2 200 rpm.

find the cost of your paper

Calculate the maximum achievable bridge out-of-balance voltage for an applied torque T of 103 N m given the following

Four strain gauges, with specification given below, are available to measure the torque on a cylindrical shaft 4 cm in diameter connecting a motor and load. (a) Draw clearly labelled….

Find the gain and phase characteristics of the maintaining amplifier.

A solid-state capacitive humidity sensor has a capacitance given by: C = 1.7 RH + 365pF where RH is the percentage relative humidity. The sensor has an associated parallel resistance….

calculate the mean velocity of the gas at maximum flow rate

A pitot tube is used to measure the mean velocity of high pressure gas in a 0.15 m diameter pipe. At maximum flow rate the mean pitot differential pressure is….