OSHA 510 Study Guide Answer Sheet
Page 1 of 4
1
True or False: Workplace injuries and illnesses can lower morale and increased cost to train replacement workers.
2
According to “The Act”, what is the mission of OSHA?
3
True or False – Section 11(c) of the OSH Act states: employers shall furnish to each employees a place of employment which are free from recognized hazards?
4
What is a Horizontal Standard?
5
True or False: OSHA directives including Enforcement and compliance directives ensures consistent enforcement of OSHA regulations.
6
True or False – If corrected yet documented at time of inspection, the employers must certify that abatement is completed for each cited violation?
7
Define Creating Employer?
8
What is the process Compliance Safety Health Officer (CSHO) uses when conducting an inspection?
9
True or False: Days the employee was only able to work a partial work shift is classified as restricted work activity.
10
When calculating incident rate, how many emploees does the 200,000 figure in the formula represent?
11
True or False: Leading by example is a way to demonstrate management leadership and commitment to Safety and health?
12
In accordance with (IAW) 1926.20(B) having a safety & health program and jobsite inspections by a competent person are two main components of an employer’s ________ __________ responsibilities.
OSHA 510 Study Guide Answer Sheet
Page 2 of 4
13
How far can a Class 2A Fire Extinguishers be away from the employees?
14
True or False: Accident prevention signs such as danger, caution and exits signs shall be visible while working.
15
What is the maximum deceleration distance a personal fall arrest system shall bring employees to a stop?
16
True or False: Only hand and power tools purchased by the employer must be maintained in a safe condition.
17
IAW Subpart C what is the definition qualified person.
18
How do you protect employee and other employees vision in the vicinity during Arc Welding operations?
19
True or False: Failure to inspect oil or grease on regulator fitting, valves or cap threads on a oxygen cylinder can result in fire or explosion.
20
How should Personal Fall Arrest System (PFAS) be rigged?
21
When using mechanical equipment perpendicular from the roof edge, how far away from the roof edge must warning line be?
22
Who initiates and maintains accident prevention programs.
23
Define Assured Equipment Grounding Conductor program.
24
True of False: When guarding live parts, areas with 45 volts or greater, requires that only a qualified person (electrician) have access to protected areas.
25
Define bonding.
OSHA 510 Study Guide Answer Sheet
Page 3 of 4
26
True or False: When working around Power Transmission & Distribution lines you only have to give an initial Job briefing at the beginning of the project if the work being performed is repetitive and similar to other task?
27
True or False: A competent person shall supervise the dismantling of scaffolding?
28
IAW Subpart M, what is the height of a the top rail of a guardrail system.
29
When must a material chute be enclosed during demolition operations.
30
Define “Type B” Soil.
31
True or False? A masonry wall must be braced when it reaches 6 feet in height?
32
True or False: On temporary stairs, handrails must have a minimum clearance of 4 inches?
33
What are the requirements for a “limited access zone” for masonry construction.
34
What is the intended load of the max intended load for self-supporting portable ladders? (Robert Kuri)
35
True or False: During Steel Erection, controlled decking zone can used as fall protection up to a maximum height of 50 feet?
36
In Accordance With (IAW) Subpart P, Appendix B, Figure B-1, when performing short-term excavations, what is the sloped ratio, duration limit, and depth limit when excavating Type A soil?
37
When must portable ladders be removed from service?
OSHA 510 Study Guide Answer Sheet
Page 4 of 4
38
When is cross bracing on a scaffold acceptable as a midrail?
39
True or False? Material handling rigging equipment only needs to be inspected once daily?
40
Who has the authority to stop crane operations?
41
IAW 1926.1419, during operations when is the operator required to safely stop operations…
42
Who is responsible for training crane signal personnel.
43
True or False: Rollover Protection materials must perform at -10 degrees Fahrenheit?
44
What regulation covers training for powered industrial trucks?
45
IAW Subpart A, which organization and regulation (incorporated by reference) covers eye and face protection.
46
What is the hierarchical control method employers use to protect employees.
47
Respirators are covered by what regulation?
48
IAW Subpart D, when is personnel certified first- aid training required?
49
How should drinking water be dispensed from portable containers?
50
True or Flase: IAW Subpart D paragraph L, excessive exposure to lead only has adverse effects on the male reproductive system.
