Find the corresponding mass flow rates for each pressure.

A compressor takes in air at atmospheric pressure (100 kPa) and discharges the compressed air into a large, high-pressure settling tank. To measure the mass flow rate of the compressed air as a function of the compression pressure, an engineer connects a converging nozzle to the settling tank. The exit area of the nozzle is 20 × 10−4 m2. In a test series with different flow rates, the following gage pressures were measured in the settling tank: 110, 160, 250, 400, and 600 kPa. For all tests, the temperature in the settling tank was approximately 350 K. Find the corresponding mass flow rates for each pressure.

find the cost of your paper

Calculate the maximum achievable bridge out-of-balance voltage for an applied torque T of 103 N m given the following

Four strain gauges, with specification given below, are available to measure the torque on a cylindrical shaft 4 cm in diameter connecting a motor and load. (a) Draw clearly labelled….

Find the gain and phase characteristics of the maintaining amplifier.

A solid-state capacitive humidity sensor has a capacitance given by: C = 1.7 RH + 365pF where RH is the percentage relative humidity. The sensor has an associated parallel resistance….

calculate the mean velocity of the gas at maximum flow rate

A pitot tube is used to measure the mean velocity of high pressure gas in a 0.15 m diameter pipe. At maximum flow rate the mean pitot differential pressure is….