Find the circular tooth thickness.

1. Preliminary design calculations have suggested that design objectives may be met by a straight spur gearset using standard full-depth 2 -pitch involute gear teeth, and a 21-tooth pinion meshing with a 28-tooth gear. A 25 pressure angle has been selected for this application, and the gear teeth are to be shaved to AGMA quality number . Find the following:

a. Addendum.

b. Dedendum.

c. Clearance.

d. Circular pitch.

e. Circular tooth thickness.

f. Base pitch .

g. Length of action.

h. Profile contact ratio.

i. Module 15-27. Repeat problem 15-26, except for a 20 pressure angle.

find the cost of your paper

Calculate the maximum achievable bridge out-of-balance voltage for an applied torque T of 103 N m given the following

Four strain gauges, with specification given below, are available to measure the torque on a cylindrical shaft 4 cm in diameter connecting a motor and load. (a) Draw clearly labelled….

Find the gain and phase characteristics of the maintaining amplifier.

A solid-state capacitive humidity sensor has a capacitance given by: C = 1.7 RH + 365pF where RH is the percentage relative humidity. The sensor has an associated parallel resistance….

calculate the mean velocity of the gas at maximum flow rate

A pitot tube is used to measure the mean velocity of high pressure gas in a 0.15 m diameter pipe. At maximum flow rate the mean pitot differential pressure is….