draw the voltage seen on the load when a= 25.

the 460 V rms 3 phase full wave controlled rectifier feeds an inductive charge. The supply voltage has a frequency of 50 Hz. If transistors are considered ideal;

a. draw the voltage seen on the load when a= 25.

b. draw the voltage seen on the load while the FWD diode is parallel to the load when a = 15 .

c. draw the voltage seen on the load when a = 75°.

d. a = 90 when there is a parallel FWD d

find the cost of your paper

Calculate the maximum achievable bridge out-of-balance voltage for an applied torque T of 103 N m given the following

Four strain gauges, with specification given below, are available to measure the torque on a cylindrical shaft 4 cm in diameter connecting a motor and load. (a) Draw clearly labelled….

Find the gain and phase characteristics of the maintaining amplifier.

A solid-state capacitive humidity sensor has a capacitance given by: C = 1.7 RH + 365pF where RH is the percentage relative humidity. The sensor has an associated parallel resistance….

calculate the mean velocity of the gas at maximum flow rate

A pitot tube is used to measure the mean velocity of high pressure gas in a 0.15 m diameter pipe. At maximum flow rate the mean pitot differential pressure is….