design a single-reduction straight spur gear unit to operate from a 5.0-hp electric motor running at 900 rpm to drive a rotating machine operating at 80 rpm.

1. Using the simplified approach (do not refine results by using AGMA equations), design a single-reduction straight spur gear unit to operate from a 5.0-hp electric motor running at 900 rpm to drive a rotating machine operating at 80 rpm. The motor is to operate steadily at full rated power. Near-infinite life is desired. A reliability of 90 percent is acceptable for this application. It is proposed to use ASTM A-48 (class 40) gray castiron material for both gears. Using , properties for this material may be based on Chapter 3 data, except for surface fatigue strength, which may be taken as psi. A safety factor of 1.3 is desired. As part of the design procedure, select or determine the following so as to satisfy design specifications:

a. Tooth system .

b. Quality level.

c. Diametral pitch.

d. Pitch diameters.

e. Center distance .

f. Face width .

g. Number of teeth on each gear. Do not attempt to evaluate heat generation.

find the cost of your paper

Calculate the maximum achievable bridge out-of-balance voltage for an applied torque T of 103 N m given the following

Four strain gauges, with specification given below, are available to measure the torque on a cylindrical shaft 4 cm in diameter connecting a motor and load. (a) Draw clearly labelled….

Find the gain and phase characteristics of the maintaining amplifier.

A solid-state capacitive humidity sensor has a capacitance given by: C = 1.7 RH + 365pF where RH is the percentage relative humidity. The sensor has an associated parallel resistance….

calculate the mean velocity of the gas at maximum flow rate

A pitot tube is used to measure the mean velocity of high pressure gas in a 0.15 m diameter pipe. At maximum flow rate the mean pitot differential pressure is….