Design a leaf spring to meet these requirements if infinite-life is desired.

1.A multileaf simply supported truck spring is to be designed for each rear wheel, using AISI 1095 steel ( , , ). The truck weight is 16 kN, with 65 percent of the weight on the rear wheels. The static midspan deflection is 100 mm and the maximum midspan deflection during operation is 200 mm. The loading may be considered to be released cyclic loading. The length of the spring between supports must be between 1.2 m and 1.6 m. It has been decided that a design factor of safety of should be used. Design a leaf spring to meet these requirements if infinite-life is desired.

find the cost of your paper

Calculate the maximum achievable bridge out-of-balance voltage for an applied torque T of 103 N m given the following

Four strain gauges, with specification given below, are available to measure the torque on a cylindrical shaft 4 cm in diameter connecting a motor and load. (a) Draw clearly labelled….

Find the gain and phase characteristics of the maintaining amplifier.

A solid-state capacitive humidity sensor has a capacitance given by: C = 1.7 RH + 365pF where RH is the percentage relative humidity. The sensor has an associated parallel resistance….

calculate the mean velocity of the gas at maximum flow rate

A pitot tube is used to measure the mean velocity of high pressure gas in a 0.15 m diameter pipe. At maximum flow rate the mean pitot differential pressure is….