Create a plan for implementing a DOE that assesses what should be done differently to reduce the amount of bending on each component. Consider the selection of measurement response, selection of factors, and results validation.

The position of the leads on an electronic component is important for getting a satisfactory solder mount of the component to an electronic printed circuit board. There is concern that an electronic tester of the component function is bending the component leads. To monitor physical changes from tester handling, the leads from a sample of components are noted before and after the tester.

(a) Create a plan for implementing a DOE that assesses what should be done differently to reduce the amount of bending on each component. Consider the selection of measurement response, selection of factors, and results validation.

(b) Create a plan that could be used in the future for a similar machine setup.

find the cost of your paper

Brenda Patton is an 18-year-old Caucasian female, G1P0 at 38 2/7 weeks of gestation admitted to the labor and birthing unit for labor assessment

Careplan for Brenda patton Brenda Patton is an 18-year-old Caucasian female, G1P0 at 38 2/7 weeks of gestation admitted to the labor and birthing unit for labor assessment. The patient….

Describe all the nine characteristics for a Bank ATM as a system

1. Describe all the nine characteristics for a Bank ATM as a system 2. For a smartphone as a system, do the following: a. Decompose the system into sub-components b…..

What is the primary difference between Backup Speed and Restore Speed?

What is the primary difference between Backup Speed and Restore Speed? Q20; Design and performance of a Call Center. In a call center there are M customer service representatives. Arriving calls are sent….