Calculate the required torque capacity.

A cone clutch having a cone angle of 10 is to transmit 40 horsepower continuously at a rotational speed of 600 rpm. The contact width of the lining along an element of the cone is 2.0 inches. The lining material is wound asbestos yarn and wire, operating against steel. Assuming that the uniform wear assumption holds, do the following:

a. Calculate the required torque capacity.

b. Calculate the change in radius of the contact cone (i.e., ) across the contact width of the lining.

c. Calculate an acceptable value for so that required torque capacity can be satisfied.

d. Calculate the corresponding value of .

find the cost of your paper

Calculate the maximum achievable bridge out-of-balance voltage for an applied torque T of 103 N m given the following

Four strain gauges, with specification given below, are available to measure the torque on a cylindrical shaft 4 cm in diameter connecting a motor and load. (a) Draw clearly labelled….

Find the gain and phase characteristics of the maintaining amplifier.

A solid-state capacitive humidity sensor has a capacitance given by: C = 1.7 RH + 365pF where RH is the percentage relative humidity. The sensor has an associated parallel resistance….

calculate the mean velocity of the gas at maximum flow rate

A pitot tube is used to measure the mean velocity of high pressure gas in a 0.15 m diameter pipe. At maximum flow rate the mean pitot differential pressure is….